16 Bolo Tiller Tines Fits Troy-Bilt Horse Pony 1901118 1245K

A complete set of sixteen 12 inch curved bolo tiller tines, eight left-hand and eight right-hand, with 32 cap screws (3/8 x 1 inch, grade 5), 32 hex nuts (3/8-16) and 32 lock washers. They fit Troy-Bilt Horse, Pony, Big Red and Econo rear-tine tillers and other tillers built with the same tine and mounting holes. Check the holes on your old tines first: these have 3/8 inch holes spaced 2-1/2 and 3-1/16 inches center to center, and tillers with 7/16 inch holes at a different spacing take a different tine. They replace part numbers 1901118, 1901118A, 1245K, 10802, 1270-1A, 1270-2A, GW-1270-1A, GW-1245, 129259, 129359, 1569, 1570, 742-0105, 742-0106, 742-04118 and 742-04119. Lay the old tines out in order as they come off and fit the new ones the same way round, check the hub flanges for wear, and use the new hardware.

• SIXTEEN BOLO TINES AND ALL THE HARDWARE - Eight left-hand and eight right-hand 12 inch curved bolo tines, with 32 cap screws (3/8 x 1 inch, grade 5), 32 hex nuts (3/8-16) and 32 lock washers.
• FITS TROY-BILT HORSE, PONY, BIG RED AND ECONO TILLERS - The rear-tine tillers that run sixteen 12 inch bolo tines. Other rear-tine tillers built with the same tine and the same mounting holes take them too.
• CHECK THE MOUNTING HOLES BEFORE ORDERING - 3/8 inch holes spaced 2-1/2 inches and 3-1/16 inches center to center. Some tillers use 7/16 inch holes at a different spacing, and these tines will not fit those.
• REPLACES 1901118, 1901118A, 1245K, 10802, 1270-1A, 1270-2A, GW-1270-1A, GW-1245, 129259, 129359, 1569, 1570, 742-0105, 742-0106, 742-04118 AND 742-04119 - If your parts list shows any of these numbers, this set covers it.
• LAY OUT THE OLD TINES FIRST - Set the old tines out in order as they come off and mount the new ones the same way round. A tine mounted backward drags instead of cutting. Check the hub flanges for wear and use the new hardware.