Gaskets Bearings Seals Fits Hilti DSH700 DSH700X Saw

Engine gaskets, crankshaft main bearings and crankshaft seals that fit the Hilti DSH700 and DSH700-X gas cut-off saws, for an engine rebuild or a crankcase reseal. A crank with play or a rough bearing, an oil-wet crank seal, or a top end coming off are the usual reasons to fit them. On these saws a hardened crank seal lets air in, the engine runs lean and the piston scores, so fit new seals whenever the crankcase is apart. Heat the crankcase halves to fit the bearings, press the seals in square without nicking the lips, clean every mating face to bare metal, and pressure and vacuum test the crankcase before the top end goes on.

• ENGINE GASKETS, CRANKSHAFT BEARINGS AND SEALS - The gaskets, main bearings and crankshaft seals for an engine rebuild on the 70cc cut-off saw.
• FITS HILTI DSH700 AND DSH700-X - The gas cut-off saws. Check the model plate before ordering.
• WHEN TO USE IT - A crank with play or a rough bearing, an oil-wet or leaking crank seal, or a top end coming off that needs fresh gaskets to go back on.
• A LEAKING CRANK SEAL KILLS PISTONS - On these saws a hardened seal lets air in, the engine runs lean and the piston scores. Fit new seals whenever the crankcase is apart.
• INSTALLATION - Heat the crankcase halves to fit the bearings, press seals in square without nicking the lips, clean every mating face to bare metal, and pressure and vacuum test the crankcase before the top end goes on.